Location: Gujeni Village, Kaduna

Job Summary

• Responsible for the installation, calibration and maintenance of instruments and control systems used to measure and regulate process variables.

Key Responsibilities

• Install and maintain sensors, transmitters, control valves and analyzers.
• Calibrate instruments to ensure accurate readings of pressure, temperature, level and flow.
• Troubleshooting and repair instrumentation faults and signal transmission problems.
• Assist in loop checks and control system testing during commissioning
• Ensure compliance with instrumentation standards and safety requirements.
• Keep detailed maintenance and calibration records
• Support engineers in system upgrades and automation projects.

Requirements

• OND, Technical Diploma, or Trade Test in Instrumentation, Electronics, or Electrical Engineering.
• 2 – 5 years of experience in instrumentation maintenance and calibration within a process, power, or industrial plant.
• Good knowledge of sensors, transmitters, control valves, and troubleshooting of PLC/DCS-based systems.

Application Closing Date
31st October, 2025.

go to method of application »

Job Summary

• Carries out routine and preventive maintenance tasks, assists in troubleshooting equipment, and supports smooth operation of plant systems.

Key Responsibilities

• Perform equipment checks, lubrication, and minor maintenance activities.
• Support in troubleshooting mechanical/electrical/instrumentation issues.
• Assist during start-up, shutdown, and maintenance of TG/Boiler units.
• Follow standard operating procedures and safety practices.
• Record maintenance activities and report issues to the supervisor.
• Maintain tools, equipment, and work areas in proper condition.

Requirements

• OND, Technical Diploma, or Trade Test in Electrical or Electronics Engineering.
• 2 – 5 years of hands-on experience in electrical installation, maintenance, and troubleshooting in an industrial setting.
• Good knowledge of motors, control panels, wiring, and safety practices.

Application Closing Date
Not Specified.

go to method of application »